Your phone supports the Mitel Line Interface Module. The Line Interface Module allows you to make and receive calls over an analog line (Line Interface Module line) connected to your phone. The Line Interface Module operates in either of the following two modes, as determined by your System Administrator:

  • Line Interface Module Mode: your phone allows you to use the Line Interface Module line at any time
  • Failover Mode: you can use the Line Interface Module line only when the IP connection has failed

    Note: Handsfree and on-hook dialing are not supported on the Line Interface Module line.

    For information on emergency number dialing using the Line Interface Module, refer to Emergency Calls.

    Making and Answering Calls Using the Analog key

    To make a call using the Analog line:
  1. Lift the handset.
  2. Press the key you programmed as Analog Line. ANALOG CALL is displayed.
  3. Dial the number.

 

Note: When you make an external call over the analog line, a prefix dialing number is not required. If your phones Analog Line key has the Privacy option enabled, you cannot access the analog line when another phone is using the analog line (key is solid orange).To access the analog line, the user of the other phone must first hang up. To determine whether the Privacy option is enabled, contact your System Administrator.

To answer a Call using the analog line:

  1. Lift the handset.
  2. Press the Analog Line key that is highlighted.

To answer a waiting call on the analog line:

Note: If you have subscribed to an analog call waiting service, you may use the hookswitch or press Cancel ( ) to answer a waiting analog call. When you are on an analog call and a waiting analog call arrives, you hear a beep. This feature may not be supported in all regions.

To answer a waiting analog call or return to the original analog call:

  1. Do one of the following:
  • Press and release the hookswitch
  • Press Cancel (  )
  1. Press the key you have programmed as Analog Line.

To put a current call on hold to answer an incoming analog call:

  • Press the highlighted Analog Line key.

To switch between the current call and the held call when one of the calls is using the analog line, do one of the following:

  • If your current call is using the analog line, press the flashing Line key of the held call. The analog call is automatically put on hold.
  • If your current call is using an IP line, press the highlighted Analog Line key. The IP line is automatically put on hold.

To end a current call when an incoming analog call arrives:

  • Press Cancel (  ) and then press the highlighted Analog Line key. The current call ends and you are connected to the caller on the analog line.

To end the current analog call when an incoming call arrives:

  • Press Cancel (  ). The current analog call ends and you are connected to the new caller.

Making and Answering Calls Using the Failover Mode

To make a call using the analog line during an IP connection failure:

  1. Lift the handset. The phone displays IP FAIL: ANALOG CALL.
  2. Dial the number.

To answer a call using the analog line during an IP connection failure:

  • Lift the handset. The call is answered. The phone displays IP FAIL: ANALOG CALL.